ATUforma GmbH
2-piece set FTC-O tire protectors for bikes, customizable
→ Flaches Design mit Auffahrhilfe für besonders leichtes Auffahren oder Aufschieben
→ Ohne Mulde kein "Einfallen" und somit besonders achsschonend
→ Alle Reifenschoner werden von Hand gefertigt
→ Personalisierbar: Dein Wunschdesign für einzigartige Sammlungen
2-piece set FTC-O tire protectors for bikes, customizable
Hammstraße 1
Hammstraße 1
67227 Frankenthal
Germany
FTC Tire Protectors - The solution for your motorcycle:
- Best possible weight distribution of the vehicle
- Prevents tire imbalances during extended periods of inactivity.
- Minimal pressure peaks
- Maximum contact area thanks to the patented Flexigel® that adapts to the tire
- Thermal insulation from the substrate and thus a significant reduction in the effects of heat and cold on the standing surface.
- Reduces lateral forces and stresses in the bodywork through the vehicle's lateral movement.
- Relieves stress on suspension and bearings
The floating mounting reduces lateral forces and stresses in the bodywork, thus relieving the suspension.
Made in Germany
-2 pieces per set
-Matt black
-Load capacity: up to 2.5 tons
-Suitable for tire widths up to 245 mm
-Dimensions 420 x 340 x 25 mm
The appearance can be freely customized according to your wishes.
Optimal tire protection in just four steps:
- Peel off the protective films from the 2 pre-mounted gel pad strips.
- Then position the FTC tire protectors individually close to the center of the tire.
- Place with the underside on the floor and press down lightly.
- Briefly reverse the motorcycle, slowly drive up - done!
FAQ
Yes, there are almost no limits to your design options for the tire protectors. If you'd like to learn more, feel free to call us for a free consultation.
Your desired design is particularly durable and abrasion-resistant thanks to back printing.
The tire itself does not touch the pressure, so there can be no wear and tear of the pressure.
Before your new tire protectors are produced, you will receive a 3D rendering of your choice.
Final changes can then be requested here.
After receiving your order, a member of staff will contact you to discuss your requirements.
If you would like to include a photo of your vehicle or a logo, for example, you will receive the appropriate email address. Then send the data to your contact person. We will then check the printability of your data. Once we have received print-ready data from you, we will create and send you an initial draft of your tire protectors according to your specifications.
If the design meets your expectations, a 3D view will be created.
Then you can release the print and we will produce your desired tire protectors.
After you approve the print job, you will receive your tire protectors within three months.
